Stopping The Engine - Shindaiwa EB600RT Operator's Manual

Engine operation
Starting a warm engine
1. Throttle position lever
1. Purge bulb
1. Starter handle

Stopping the engine

1. Throttle position lever
The starting procedure is the same as Cold Start except DO
NOT close the choke.
1. Throttle Position Lever
Move throttle position lever to idle position.
2. Purge Bulb
Pump purge bulb until fuel is visible. Pump purge bulb an ad-
ditional 4 or 5 times.
3. Recoil Starter
Place the blower on a flat, clear area. Hold the blower firmly
with left hand and pull out the starter grip gently at first, and
rapidly pull recoil starter handle/rope until engine fires. If en-
gine does not start after 5 pulls, use cold start procedures.
1. Throttle position lever
Release throttle trigger. Move Throttle position lever forward
to idle position (first detent away from W.O.T. position) and al-
low engine to return to idle before shutting off engine.
2. Throttle position lever
Move Throttle position lever all the way forward to
position.
If engine does not stop when Throttle position lever is
moved to STOP position, close choke -
engine. Have your shindaiwa dealer repair stop switch be-
fore using blower again.
18
WARNING
position- to stall
(Stop)