Table of Contents
Advertisement
Coded Emergency Override
In case your Remote Transmitter becomes inoperable, lost or stolen, you can still enter and drive your car by using the
following procedure. Be sure that you have your ignition keys ready and that you know the location of the Override switch
before you perform this procedure.
To override the system:
1. Unlock the door using the key.
2. Enter the vehicle.
• Because the system is armed, the system will trigger and the siren will be sounding.
3. Turn ignition key on.
4. Press the Override switch a number of times equal to the disarm code and continue holding for 10 seconds on the
last press.
• The system will disarm.
5. You can now start and drive the car.
6. If the disarm code is not entered correctly, turn off theignition and begin again at step 3.
Note: During installation, the system can be programmed to give a 15 second entry delay when the system Arms passively.
When the door is opened while the system is Armed, the siren will give a series warning of chirps before sounding,
giving you time to perform the emergency override procedure.
Setting the Emergency Override/Disarm Code
The default setting for the Emergency Override Disarm Code is 1.
To change the Emergency Override Disarm Code:
1. Make sure the system is disarmed.
2. Turn the ignition key on.
3. Wait at least10 seconds.
4. Enter the desired disarm code then continue to hold the Override switch on the last press for 10 seconds.
• The siren will chirp 3
5. Release the switch.
6. Enter the code again and hold for 10 seconds on the last press.
• The siren will chirp 3 times.
• The parking lights will flash 3 times.
• The LED will flash a number of times equal to the new
7. Release the switch.
8. Turn off the ignition.
Automatic System Rearming
This feature, which can be turned on by your installer during the installation, insures the security of the system by protecting
your car in case of an accidental disarm.
If your system becomes disarmed due to an accidental press of the Disarm Button, the system will automatically rearm if no
other activity is detected within one minute.
One minute after Remote Disarming, the system will alert you with a series of chirps, then arm. (If the Passive Door Locking
feature is selected during the installation, the system will also relock the doors.)
Any of the following will cancel Automatic System Rearming:
• Turn on the ignition.
• Open the Trunk or Hood.
• Activate Auxiliary Function 1 or 2.
Automatic System Rearming is independent of Passive Arming and only takes place if the system was Armed (actively or
passively) for at least 10 seconds and then Disarmed by the Remote Transmitter.
times.he s
code.siren will chirp 3 times.
MS2004 Installation Manual - Page 8
Advertisement
Table of Contents
