Husqvarna Automower 520 Operator's Manual page 17

B
A
Note:
The product must be manually moved between
the main area and the secondary area.
• Put the boundary wire around the secondary area
(B) to make an island. Refer to
on page 16 .
Note:
The boundary wire must be put as 1 loop
around all of the work area (A + B).
Note:
When the product cuts grass in the
Secondary area mode must
secondary area, the
Operating mode - Start on
be selected. Refer to
page 29 .
3.4.4 To examine where to put the guide
wire
• Put the guide wire in a line at a minimum of 2 m / 7
ft. in front of the charging station.
• Make as much free area as possible to the left of
the guide wire when facing the charging station.
To examine where to put the charging
Refer to
station on page 13 .
• Put the guide wire minimum 30 cm / 12 in. from the
boundary wire.
• Do not make sharp bends when you install the
guide wire.
135º
135º
• If the work area has a slope, put the guide wire
diagonally across the slope.
1439 - 015 - 23.11.2022
3.4.5 Work area examples
•
To make an island
•
•
•
•
90º
If the charging station is put in a small area (A),
make sure that the distance to the boundary wire
is at a minimum 3 m / 10 ft. in front of the charging
station.
If the work area has a passage (B) with no
guide wire installed, the recommended minimum
distance between the boundary wires is 2 m / 6.5
ft. With a guide wire installed through the passage,
the recommended minimum distance between the
boundary wires is 60 cm / 24 in.
If the work area has areas which are connected by
a narrow passage (B), you can set the product to
first follow and then leave the guide wire after a
certain distance (C). The settings can be changed
Lawn coverage on page 25 .
in
Use the GPS Assisted Navigation that helps the
product select the most optimal operation. Refer to
Lawn coverage on page 25 .
If the work area includes a secondary area
(D), refer to Secondary area on page 29 . Put
the product in the secondary area and select
Secondary area mode .
Installation - 17