Husqvarna Automower 520 Operator's Manual page 24

Note:
Spiral cutting is only started in the Main area
Secondary area mode does not let
mode. Cutting in the
Spiral cutting . Spiral Cutting does not
the product to start
start in slopes steeper than 15%.
Settings > Operation in the app.
1. Select
2. Select On/Off to enable or disable Spiral cutting .
Settings > Spiral Cutting > Use > Intensity
3. Select
to select the level of the function.
Save .
4. Select
3.11.3.2 Weather timer
Weather timer automatically adjust the cutting time to
the growth of the grass. The product is not permitted to
operate more than the schedule settings.
Note:
Weather timer , it is recommended
When using
to make as much operating time as possible available
Weather timer . Do not restrict the schedule more
for
than necessary.
The first operation of the day is set by the schedule
settings. The product always complete 1 mowing cycle,
Weather timer selects if the product will
and then
continue to operate or not.
Note:
Weather timer is reset if the product does not
operate for more than 50 hours, or if a
settings is done. Weather timer is not changed if a Reset
of schedule settings is done.
To set the Weather timer
Settings > Operation in the app.
1. Select
2. Select on/off to enable or disable the Weather
timer .
Note:
If the cutting results are not satisfactory,
the cutting time can be adjusted. Set the cutting
High to cut for a longer time or Low to cut for
time
a shorter time.
Save .
3. Select
24 - Installation
3.11.3.3 ECO mode
ECO mode is activated, it switches off the signal in the
If
boundary loop, the guide wire and the charging station,
when the product is parked or is charging.
Note:
interference with other equipment, for example hearing
loops or garage doors.
Note:
push the STOP button before you remove the product
from the charging station. If not, the product cannot be
started in the work area.
To set the ECO mode
1. Select
2. Select
function.
3. Select
3.11.4 Installation
In the Installation menu it is possible to adapt the
settings of the product for best mowing result.
3.11.4.1 To find the charging station
The product can be set to search for the charging station
in 3 methods:
Charging station signal
•
Follow boundary wire
•
Follow guide wire
•
The factory setting is set to use the 3 search methods
at the same time. Use the factory setting to find the
charging station as fast as possible and to keep the risk
of tracks on the lawn to a minimum. The product always
starts to search for the
Reset of all user
a specified time interval, it also uses
Follow boundary wire .
Causes why the product cannot follow the wire:
• Obstacles near the wire have not been isolated.
• The charging station, the boundary wire or the
guide wire are not installed according to the
instructions in
page 18 , To install the boundary wire on page 19
and in
To change the signal range of the charging station
For some installations it is necessary to decrease the
signal of the charging station. For example when the
charging station is put near an obstacle such as a
bush or wall and the signal reaches to the other side
ECO mode to save energy and avoid
Use
To start the product manually in the work area,
Settings > Operation in the app.
on/off to enable or disable the ECO mode
Save .
Charging station signal . After
Follow guide and
To install the charging station on
To install the guide wire on page 19 .
1439 - 015 - 23.11.2022