Setup; When Using The Emulator On A Stand-Alone Basis For Performing Software Debugging - NEC IE-V850ES-G1 User Manual

1.7 Setup

The following two system configurations for the IE-V850ES-G1 are possible, depending on the purpose.
This section describes the setup procedure according to each purpose as follows.

1.7.1 When using the emulator on a stand-alone basis for performing software debugging

(1) Connect interface board to PC
Before connecting, turn off the PC.
(2) Connect emulation board
(3) Set operation clock of emulator
(4) Connect PC interface cable
Connect cable.
(5) Power up PC, then IE-V850ES-G1
CHAPTER 1 OVERVIEW
Step Reference section
3.1 Connection to Personal Computer
Refer to the user's manual of the emulation board
Refer to the user's manual of the emulation board
3.4 Cable Connections
3.5 System Power-on and Power-off
User's Manual U16313EJ1V0UM
19