Table of Contents
Advertisement
1.6 Setup
The following two system configurations for the IE-V850E-MC-A are possible, depending on the purpose.
This section describes the setup procedure according to each purpose as follows.
1.6.1 When using the IE-V850E-MC-A on a standalone basis for performing software debugging
(1)
Connect interface board to PC
Before connecting, make sure that the power of the PC is off (when using PCI bus).
(2)
Connect option board
(3)
Set clock operation mode of IE-V850E-MC-A
(4)
Set CPU operating voltage range
Switch CPU operating voltage range.
(5)
Connect cables
Connect power source adapter and interface cable.
(6)
Power up IE-V850E-MC-A
(7)
Start debugger
CHAPTER 1 OVERVIEW
Step
Reference section
3.1 Connection to Personal Computer
Refer to the user's manual of the option board
Refer to the user's manual of the option board
Refer to the user's manual of the option board
3.3 Cable Connections
3.4 System Power-On and Power-Off
3.4 System Power-On and Power-Off
User's Manual U14487EJ2V0UM
17
Advertisement
Table of Contents
