Yamaha Autopilot Overlay Bar; Force Trolling Motor Control; Connecting To A Trolling Motor - Garmin ECHOMAP UHD2 6 SV Owner's Manual

Yamaha Autopilot Overlay Bar

Autopilot mode
Actual heading
Intended heading (heading the autopilot is steering toward)
Opens the full autopilot screen and menu
Do not run the motor when the propeller is out of the water. Contact with the rotating propeller may result in
severe injury.
Do not use the motor in areas where you or other people in the water may come into contact with the rotating
propeller.
Always disconnect the motor from the battery before cleaning or servicing the propeller to avoid injury.
You are responsible for the safe and prudent operation of your vessel. The autopilot features on the trolling
motor are tools that enhance your capability to operate your boat. They do not relieve you of the responsibility
of safely operating your boat. Avoid navigational hazards and never leave the motor controls unattended.
Learn to operate the autopilot on calm and hazard-free open water.
Use caution when operating the autopilot near hazards in the water, such as docks, pilings, and other boats.
When using the autopilot features, be prepared for sudden stops, acceleration, and turns.
When stowing or deploying the motor, be aware of slick surfaces around the motor. Slipping when stowing or
deploying the motor may result in injury.
You can connect the Force trolling motor to the chartplotter to view and control the motor using the chartplotter.

Connecting to a Trolling Motor

You can connect the chartplotter wirelessly to a compatible Garmin Force trolling motor on your boat to control
the trolling motor from the chartplotter.
1 Turn on the chartplotter and the trolling motor.
2 Enable the Wi‑Fi network on the chartplotter
3 If multiple chartplotters are connected on the Garmin Marine Network, make sure this chartplotter is the host
of the Wi‑Fi network (Changing the Wi‑Fi Host,
4 On the chartplotter, select Settings > Communications > Wireless Devices > Garmin Trolling Motor.
5 On the trolling motor display panel, press
on the trolling motor display panel is solid blue as it searches for a connection to the chartplotter, and
turns green when the connection is successful.
After the chartplotter and trolling motor connect successfully, enable the trolling motor overlay bar to control
the motor (Adding the Trolling Motor Controls to Screens,
Force Trolling Motor Control
®
Force Trolling Motor Control
®
WARNING
CAUTION
(Setting Up the Wi‑Fi Network,
page 14).
three times to enter pairing mode.
page 12).
page 90).
89