Communications Settings; Viewing Connected Devices; Nmea 2000 Settings; Setting Alarms - Garmin ECHOMAP UHD2 6 SV Owner's Manual

Communications Settings

Viewing Connected Devices

You can view lists of the connected devices on the vessel including which chartplotter a device is connected to
or paired with.
1 Select Settings > Communications.
2 Select a network.
3 Select Device List.
A list of network devices appears. If a device is connected to or paired with a specific chartplotter, the name
of the chartplotter is shown along with the device name.
NOTE: Some devices included in the NMEA 2000 device list may be connected to a chartplotter at another
station on the vessel. You can select Related To: to see more information about which chartplotter the
device is connected to.

NMEA 2000 Settings

Select Settings > Communications > NMEA 2000 Setup.
Device List: Displays the devices connected to the network and allows you to set options for some transducers
connected using the NMEA 2000 network.
Label Devices: Changes the labels for available connected devices.
Naming Devices and Sensors on the Network
You can name devices and sensors connected to the Garmin Marine Network and the NMEA 2000 network.
1 Select Settings > Communications.
2 Select Marine Network or NMEA 2000 Setup > Device List.
3 Select a device from the list on the left.
4 Select Change Name.
5 Enter the name, and select Done.

Setting Alarms

The Beeper setting must be turned on to make alarms audible
to set audible alarms could lead to injury or property damage.

Navigation Alarms

Select Settings > Alarms > Navigation.
Arrival: Sets an alarm to sound when you are within a specified distance or time from a turn or a destination.
Anchor Drag: Sets an alarm to sound when you exceed a specified drift distance while anchored.
Off Course: Sets an alarm to sound when you are off course by a specified distance.
Boundary Alarms: Disables and enables all boundary alarms.
Setting the Anchor Drag Alarm
You can set an alarm to sound if you have moved more than an allowable distance. This is very useful when
anchoring overnight.
1 Select Settings > Alarms > Navigation > Anchor Drag.
2 Select Alarm to turn on the alarm.
3 Select Set Radius, and select a distance on the chart.
4 Select Back.
Device Configuration
CAUTION
(Sounds and Display Settings, page 120). Failure
125