Initial Setup
Symptom
E2T does not come up
even though the network
settings have been
programmed.
23
Possible Cause
E2T was hard coded
with an IP address and
then later changed to
request an IP address
from the DHCP server.
This change is made
by changing the flags
(f) parameter in the
bootline of the E2T
from 0x0(hardcode) to
0x40 (DHCP). If any
IP addresses remain
on the E2T (at "inet on
ethernet", "host inet"
or "gateway inet"), the
E2T will use them and
will obtain the rest of
its parameters from the
DHCP server.
Corrective Action
When changing the flag from 0x0
to 0x40 on E2T, ensure that you
blank out ALL IP addresses in the
bootline of E2T.
Refer to "Programming the E2T via
a Debug Cable or Secure Telnet" in
the Technician's Handbook.
Document Version 1.0
Troubleshooting Guide