Copy Problems; Jam; Duplex Unit; Fusing Unit - Ricoh Jupiter-C1 Technical Bulletin

th
Updated: 30
Model:
Jupiter-C1

2. Copy Problems

Subject
Skew Booklet finisher: The
edges of folded sheets are
not parallel (50–100mm
booklet skew)

3. Jam

Subject
Finisher With series printing if the
jam stapling positions for the
1st and 2nd jobs are
different and the 1st job is
set for stapling under
unsupported conditions
(e.g. only one sheet in the
stack).
Jam in the

duplex unit

Jam in the The operator makes high-

fusing unit

volume print jobs on a
daily basis
The operator sometimes
makes high P/J print jobs
T
echnical
December 2007: Changes in bold italics
Symptom RTB #
040
Symptom RTB #
001a
024
041
B
ulletin
Date:
15-Sep-04
Cause
Grounding Be careful during installation.
plate damaged Repair or replace the
during grounding plate.
installation
Cause
Engine Install the latest engine
firmware firmware (ver 1.11 or later)
Mylars not Replace seven Mylars (P/N
installed G3484682).
correctly. See the RTB for the
Mylars not the replacement procedure.
correct shape
The machine Install the new Oil Supply
cannot supply Unit. P/N: B1499500
enough fusing Install only if ACV/APV is 15K
oil to the fusing prints or more.
unit. Do not install this unit if
operators use the machine at
normal print volume.
PAGE: 5/12
No.:
RB149000h
Solution
Solution
Note
Note