Lennox Smart Devices Details; Smart Room Sensor; Pairing/Factory Reset Button, Battery Compartment And Light Display Location; Light Indicators - Lennox 22V26 Installation And Setup Manual

Lennox Smart Devices Details

Smart Room Sensor

This section provides details on the Smart Room
Sensor buttons, battery compartment, stand and light
indicator location.
P /F r
airing actory eset
L
ight
Front Cover (removable)
Occupancy
Fresnel Lens
LED Light Pipe
Opening Latch (Depress
and pull tab to
remove front cover)
NOTE: LED light pipe is not visible on top of plastic surface.
User will see illumination on the front plastic when LED is on.
Figure 1. Sensor Light Indicator, Buttons, Sensor Vents,
Battery Compartment Locations
B , B c
utton attery omPartment and
d L
isPLay ocation
Occupancy Sensor
Battery compartment
for two AA lithium batteries
Relative Humdity
and Temperature
Sensors
Sensor Stand
Pairing / Factory
Reset Button
Table 1. Sensor - Three Color Descriptions
Function Color
Battery RED
Signal
BLUE
Strength
Pairing GREEN
8
L i
ight ndicators
Description
A flashing red light in one minute
intervals indicates the battery is
low (20%). When the red light is off
it indicates battery life is good.
A flashing blue light in five (5)
minute intervals indicates the
signal strength is low or connection
to the thermostat is lost.
When the blue light is off it
indicates signal strength is good
and connected to the smart device
network.
• When batteries are inserted into
a new or unpaired device the unit
will automatically go into pairing
mode (flashing green light). The
unit will stay in pairing mode
for three (3) minutes. To restart
pairing mode, press the pairing
button for two (2) seconds.
• When a device has been paired
to the thermostat and new
batteries are installed, the unit
will flash a green light three times
after powering up.