Outlet Line Power; Applying Power To The Smart Devices; Smart Room Sensor - Lennox 22V26 Installation And Setup Manual

Table 2. Wireless Extender Light - Two Color Descriptions
Color
Function
Light
Signal
BLUE
Strength
Pairing GREEN
o
utLet
The device is powered by an 120VAC outlet.
Description
A solid blue light indicates
the signal strength is low or
connection to the thermostat
is lost.
When the blue light is off it
indicates signal strength is
good and connected to the
smart devices network.
When a paired Wireless
Extender is powered up, it will
flash green three (3) times.
When a unpaired Wireless
Extender is powered up, it will
flash green for two (2) minutes
which indicates the units is in
pairing mode.
L P
ine ower

Applying Power to the Smart Devices

Smart Room Sensor

1. Depress and pull tab to remove smart room
sensor front cover (see "Figure 1. Sensor Light
Indicator, Buttons, Sensor Vents, Battery Com-
partment Locations" on page 8 for details).
2. Remove the insulation tape located between the
battery and the sensor's positive (+) terminal
(see "Figure 3. Insulation Tape Removal" on
page 10).
Remove battery
insulation tape
Figure 3. Insulation Tape Removal
Once insulation tape is removed the unit will automat-
ically go into pairing mode (flashing green light). The
10