Table of Contents
Advertisement
Using the Lennox Smart Thermostat App
A D D S E N S O R O R E X T E N D E R U S I N G T H E
T H E R M O S T A T A P P
NOTE: Smart devices cannot be added to the smart devices network until after
the technican creates the smart devices network and adds the first device using
the Lennox Technican App.
Home Screen
Menu
Settings
Figure 5. Adding Smart Device Using the Lennox Smart
Thermostat App
NOTE: The Lennox Smart Thermostat App must
be connected to the thermostat to perform
the following procedure.
Add Device
Name Smart
Device
Add another?
Yes
13
IMPORTANT
The first device must be added by the technician
in order to create the smart devices network.
Afterwards the homeowner can add or remove
devices using the Lennox Smart Thermostat App.
1. Open the Lennox Smart Thermostat App and
from the home screen select Menu in the upper
left-hand corner of the screen.
2. Under System select Settings.
3. Under Devices select Add Devices.
4. Follow the screen prompts for adding a sensor
or extender to an existing sensor network.
NOTE: When naming smart devices no blank spac-
es or special characters are allowed.
Smart Devices Installation
Smart Room Sensor
• Locate the desired location for the Smart Room
Sensor.
• If the Smart Room Sensor is out of range of your
S40 thermostat (approximately 70 feet (21.3
meters) a blue light on the device will indicate so
with the blue light flashing every five (5) minutes)
P
Lacement
Advertisement
Table of Contents
