Performing Smart Device Factory Reset; Cycling Power For Troubleshooting; Occupancy Detection Feature For Temperature Averaging; Enabling Room Averaging Using Occupancy Detection - Lennox 22V26 Installation And Setup Manual

Performing Smart Device Factory Reset

Use the following procedure to perform a factory re-
set if the device being removed is operable.
1. Press and hold the Pairing button for ten (10)
seconds.
2. If successful a flashing green light will appear
on either device. This indicates the devices can
be paired again to a smart device network.

Cycling Power for Troubleshooting

Use the following procedures to cycle power:
1. Smart Room Sensor: To cycle power on the
sensor, remove the sensor batteries and then
reinstall them.
2. Wireless Extender: To cycle power on the
wireless extender, unplug the device from the
wall outlet and then reinstall.
Occupancy Detection Feature for
Temperature Averaging
Enabling Room Averaging using Occupancy
Detection
The following two features can be set using either the
thermostat or Lennox Smart Thermostat App using
the system setting screen.
From the home screen, go to Menu > System > Set-
tings > Current Temperature.
Back
System Info TV Room
Settings
Wi-Fi
Away
Participating Sensors in Temperature Averaging Based on Occupancy
Current Temperature
Fan
Heat/Cool
Humidity
iHarmony Zoning
Notifications
Peak Monitoring
Ventilation
Devices
TSTAT
Battery Sensor
Light Switch
Figure 7. Thermostat Current Temperature Screen
17
System Settings
Current Temperature
Feels Like
Thermostat
Laura's Room
TV Room
TV Room
Off
Off
On
On