Trane FIAECON102 Series Installation Instructions Manual page 12

Installation - FIAECON103*
Figure 14. Outdoor air damper assembly installation
Secure To Return
Duct Flange
6. Refer to the barometric relief accessory literature 
(ACC-SVN156*-EN) and install the barometric block-off
panels and gasket.
Figure 15. Gasket locations for barometric relief
1.0 in. x 1.0 in.
Gasket Placement
Figure 16. Installation of barometric relief with LLE
Barometric
Relief Screws
7. Install the outside air block-off panel on the left side of the
outdoor air damper assembly as shown in
12
Outdoor Air Damper
Assembly
1.0 in. x 1.0 in.
Gasket
0.88 4.3
1.0 in. x 1.0 in. Gasket
Figure 17.
Figure 17. Outside air block-off panel installation
Outdoor Air Damper Assembly
Outside Air Block-off
8. Secure outdoor air damper assembly to the return air front
block-off that was previously installed in
Figure 18. Front damper assembly attachment to block-
off
Secure Outdoor
Air Damper Assembly
to Front Block-off Panel
with screws
9. Route the controls harness from the actuator to the fresh
air options module located in the return enclosure using the
factory installed wire ties. Connect harness P11 to fresh air
options module J11. Confirm the harness has a secure
connection.
Note: Wire ties have a releasable feature to allow them to be
opened and closed.
Step 4.
ACC-SVN264B-EN