Packaged rooftop air conditioners cooling and gas/electric (68 pages)
Summary of Contents for Trane Precedent FIAECON002 Series
Page 1
Installation Instructions Economizer Precedent™ Packaged Rooftop Units with Symbio™ Controls Model Number: Used With: FIAECON002* T/YS*072-150 SAFETY WARNING Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury.
Page 2
When working with or around hazardous chemicals, these compounds have the same potential impact to the ALWAYS refer to the appropriate SDS and OSHA/GHS environment. Trane advocates the responsible handling of all (Global Harmonized System of Classification and refrigerants-including industry replacements for CFCs and Labeling of Chemicals) guidelines for information on HCFCs such as saturated or unsaturated HFCs and HCFCs.
Page 3
Copyright This document and the information in it are the property of Trane, and may not be used or reproduced in whole or in part without written permission. Trane reserves the right to revise this publication at any time, and to make changes to its content without obligation to notify any person of such revision or change.
General Information Inspection 1. Unpack all components of the kit. 2. Check carefully for shipping damage. If any damage is found, report it immediately, and file a claim against the transportation company. 3. Visually inspect the components for shipping damage as soon as possible after delivery, before it is stored.
Field Installed Assembly and Installation Reconfigure the Damper This section covers installation of economizer units not installed in the rooftop unit at the factor. (for Horizontal Installation only) Unpack Economizer The economizer damper is pre-configured at the factory for downflow applications.
Field Installed Assembly and Installation Optional Sensors 11. Install the bottom blockoff 21 and secure it with three screws 23. If the optional sensors for humidity and temperature monitoring 12. Using field supplied silicone, apply sealant around are needed (FIAENTH001* and FIAENTH002*), install them economizer hood 24.
Field Installed Assembly and Installation Horizontal Configuration 5. Secure the economizer assembly with two screws 22 at the bottom of the corner posts. 6. Install 21 and secure with three screws 23. WARNING 7. Using field supplied silicone, apply sealant around Hazardous Voltage! economizer hood 24.
Field Installed Assembly and Installation Reference Enthalpy Settings without movement, it can be assumed it is at the new position. Economizer enthalpy changeover is field selectable and has a 3. Replace the filter access panel. range of 50-140°F. The default is 60°F. This selection can be The damper will close when the blower circuit is ...
Page 12
For more information, please visit trane.com or americanstandardair.com. Trane and American Standard have a policy of continuous product and product data improvement and reserve the right to change design and specifications without notice. We are committed to using environmentally conscious print practices.