Quick Start-Up - Microtek ScanMaker i700 User Manual

Quick Start-up

Quick Start-up
The Scanning sequence is done in six easy steps.
Step 1. Install Microtek ScanWizard 5
Step 2. Position your original material
Step 3. Launch ScanWizard 5
Step 4. Scan your material
Step 5. Save your scan material
Step 6. Exit ScanWizard 5
Step 1. Install Microtek ScanWizard 5
Install the ScanWizard 5 scanner driver (included in your Microtek CD-
ROM) as instructed in a separate document that came with your scanner
package.
For ScanWizard 5 to work properly after installation, the correct scanner
model should be properly connected to your computer beforehand and
must be "powered on" before ScanWizard 5 is launched.
Step 2. Position your original material
Place your material face down on the scanner bed.
Step 3. Launch ScanWizard 5
A. Launching ScanWizard 5 as a stand-alone program
Double-click the ScanWizard 5 icon
B. Launching from an image-editing application
file:///D|/sw56/Quick_Start-up.htm (1 of 2) [8/15/03 3:50:43 PM]
on your desktop; or