Microtek ScanMaker i700 User Manual page 105

Menu bar
scanner list is used, and ScanWizard 5 will not find or add any new
scanners to the scanner list. This is a short-cut command without
invoking the Scanner Driver Manager.
Scanner Probe
This command displays the detected scanner devices.
If your scanner does not show in the list, make sure it is connected
and turned on, then click on the Probe button in the dialog box.
Find scanners
To add a scanner:
Follow the hardware installation instructions for connecting a
scanner to your system. Then use the Scanner Driver Manager in
ScanWizard 5 to find the connected scanner in your scanner list.
1. Go to the Scanner menu in the Preview window, and choose
Scanner Driver Manager. A dialog box will appear showing the
connected scanner and the corresponding interface ID number.
2. Click the Find Scanners button. In case you have added new
scanners, the newly found scanners will be appended to the
scanner list. If a scanner on the list is not detected (not turned
on, not ready, or removed from the system), the model will
not be removed from the list but will have a question mark
before it.
3. Click the Close button to close the dialog box.
Remove scanner (unimplemented)
To remove a scanner from your scanner list:
1. Go to the Scanner menu in the Preview window, and choose
Scanner Driver Manager.
file:///D|/sw56/Menu_bar.htm (3 of 20) [12/16/03 11:57:50 PM]