Fast Overview - Microtek ScanMaker i700 User Manual

Menu bar
Maximum area or a Custom area.
Maximum refers to the maximum area that can be overviewed.
The dimensions of the maximum area vary, depending on your
scanner model. Take note that transmissive scan areas are
smaller.
Custom refers to the area as determined by the dimensions
you specify in the Left/Top/Width/Height settings in the dialog
box.
Left, Top, Width, Height
These edit boxes let you specify the dimensions of the overview
area.
Top and Left refer to the starting points of the overview area
on the X and Y coordinates.
Width is the expanse of the overview area. Height is the depth
of the overview area.
Keep Overview Image After Quit
If this box is checked, the overview image will be kept when you
quit ScanWizard 5, and the same overview image will be displayed
again when you run ScanWizard 5 the next time.

Fast Overview

If this box is checked, the overview process is speeded up. The
trade-off to increased speed is a slightly downgraded overview
image. If you do not care about the image quality of the overview
image, check this box.
Warn Me if Overwriting Prescan
If this option is checked, a confirmation message appears, notifying
you that a previously prescanned image exists. This confirmation is
file:///D|/sw56/Menu_bar.htm (13 of 20) [12/16/03 11:57:50 PM]