Table of Contents
Advertisement
During a call
A sound and a message on the display indicate when encryption is disabled on the base during
a call.
Continue call:
Stop call:
If neither is pressed, the call is stopped automatically after a certain time.
Testing the secure connection status during a call:
Press the Hash key
display
Changing the handset PIN
The handset is protected against unauthorised use by a PIN. The handset PIN must be entered
e. g. when switching off the keypad lock.
Change the handset's 4-digit PIN (default setting: 0000):
Settings
the current PIN
If the correct handset PIN is not entered after 5 failed attempts, a 15-second timer is
started. Every failed attempt thereafter doubles the timer (up to a maximum delay of
8 hours between PIN entry attempts).
Handset update
The handset supports firmware updating via the DECT radio link to the base/router
(SUOTA = Software Update Over The Air).
The base/router to which the handset is registered must also support this function
(
wiki.gigasetpro.com)
If your base/router does not support this function, you can also update the firmware
via a USB cable and Gigaset Quick Sync.
The phone checks whether new firmware is available for the handset. If it is, a message is
displayed.
Start the firmware update with Yes.
Enable/disable automatic check for new firmware:
Settings
Automatic Check
Yes
No
for a longer time . . . the secure connection status is shown on the
OK
System
OK
enter the new handset PIN
OK
System
OK
Change (
Availability and operation of the functions
may differ on your telephone.
OK
Handset PIN
OK
OK
Handset Update
= enabled)
Setting the handset
OK
enter
OK
65
Advertisement
Table of Contents
