Check Digits Required; Code 11 Message Length; Code 11 Redundancy - Honeywell HF52X User Manual

Check Digits Required

This option sets whether 1 or 2 check digits are required with Code 11 bar codes.
Default = Two Check Digits.

Code 11 Message Length

Scan the bar codes below to change the message length. Refer to
Description
= 1-80. Minimum Default = 4, Maximum Default = 80.
Minimum Message Length

Code 11 Redundancy

If you are encountering errors when reading Code 11 bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the Code 11 Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the
Save bar code. Default = 0.
HF52X Fix Mount Barcode Scanner User Guide
One Check Digit
(page 80) for additional information. Minimum and Maximum lengths
Programming
Code 11 Redundancy
* Off
* Two Check Digits
Message Length
Maximum Message Length
Chart. Then scan the
97