Mode 6 & 7: External Target Temperature Input Operation: View Display - Camus Hydronics DynaFlame DFW501 Installation, Operation And Service Manual

6.11 MODE 6 & 7: EXTERNAL TARGET TEMPERATURE INPUT OPERATION: VIEW DISPLAY
From the Home display;
1) Press [ITEM] to view the following parameters:
Display
37
Parameter
Parameter Description
Name
To provide a target setpoint for
Boiler Target
the heating system. Setpoint is
Temperature
controlled to the inlet sensor.
Real-time System Temperature
System
Temperature NOTE: This parameter is only
available in Mode 7
Boiler Outlet Real-time Outlet Temperature to
Temperature Boiler
Boiler Inlet Real-time Inlet Temperature to
Temperature Boiler
Real-time temperature difference
Boiler Delta between the outlet sensor and
T the inlet sensor.
Real-time modulating output
Modulation
percentage
Monitors the amount of
operational time since the
MicoFlame was installed. The
Total Run first two digits are the number of
thousands of hours and the three
Time Since
digit display shows the number of
Installation
hundreds of hours.
Press
reset the counter
---, 35 to 266
(---, 2 to 130
14 to 266
(-10 to 130
14 to 266
(-10 to 130
14 to 266
(-10 to 130
-99 to 252
(-72 to 122
0 to 100%
Alternates between
00 and 999
simultaneously to
Parameter Range
o
F
o
C)
o
F
o
C)
o
F
o
C)
o
F
o
C)
o
F
o
C)