Mounting; Fastening To The Built-In Cabinet - Smeg Dolce Stil Novo PM6954R Manual

edge of the hob before assembly.
Do not use silicone to secure the hob.
This would make it impossible to remove
the hob without damaging it.
Semi-flush mounting (mm)
X Y
Mod.
555 - 482 -
A 65
560 486
cm
Mod.
719 - 482 -
B 75
724 486
cm
Mod.
844 - 482 -
C 90
848 486
cm
1 Gas connection
2 Electrical connection

Mounting

Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
91477A185/C
F G H K
69 85 35 93
69 53 35 66
70 112 35 75
the appliance installed below.
1 Opens on bottom
2 Opens on bottom and back
On an empty kitchen
If there are other pieces of furniture under the
hob, a double-layer wooden base must be
installed at least 20 mm from the bottom of the
hob to avoid any accidental contact. It must
only be possible to remove the double-layer
base using suitable equipment.
1 Opens on bottom
2 Opens on back
A min. 20 mm - max. 50 mm
B max. 50 mm
C max. 50 mm
Failure to install the double-layer
wooden base exposes the user to
possible accidental contact with sharp
or hot parts.

Fastening to the built-in cabinet

To ensure the hob is fixed and centred as
accurately as possible, the clips provided must
be positioned as described below:
INSTALLATION - 59