Preliminary Operations; Using The Accessories; Basic Functions; Using The Hob - Smeg Dolce Stil Novo PM6954R Manual

Preliminary operations

See General safety instructions.
To remove any moisture that may have
accumulated during the manufacturing process
in order for the electronic circuits and the
controls area to work correctly:
• Remove any protective film from the outside
or inside of the appliance, including any
accessories (if present).
• Remove any labels (apart from the technical
data plate).

Using the accessories

Trivet
The trivets and reduction pan supports must be
placed on the hob pan supports. Make sure
they are placed properly.
The trivet should only be used on the UR burner.
Cookware suitable for use in induction
cooking
Cookware used on the induction cooking
surface must be made of metal, with magnetic
properties and a sufficiently large base.
Suitable cookware:
• Enamelled steel cookware with thick bases.
• Cast iron cookware with an enamelled
base.
• Cookware in multilayer stainless steel, ferritic
stainless steel and aluminium with a special
base.
Unsuitable cookware:
• Copper, stainless steel, aluminium, fireproof
glass, wood, ceramic and terracotta
cookware.
Cookware diameters
To ensure that the appliance detects the
containers correctly and for best results, use the
91477A185/C
pan sizes indicated in the following table.
Minimum diam-
Cooking zones
eter (mm)
1 - 2 (Single) 90 - 110
1 - 2 (Bridge) 190 - 230
Bear in mind the following:
• Pans should not extend beyond the lines
marked on the surface of the appliance.
• Do not place pans near to the edges of the
glass ceramic surface or close to the control
panel.
• If you use a griddle, it must have a maximum
size of and 36 x 20 cm for zones 1 - 2.
Practical tips for using the hob
For better burner efficiency and to minimise gas
consumption, use pans with lids and of suitable
size for the burner, so that the flames do not
reach up the sides of the pan. Once the contents
come to the boil, turn down the flame far
enough to ensure that the liquid does not boil
over.
Burner
AUX
R
UR
UR-3c

Basic functions

First power connection
When connected to the power supply for the
first time, or after power has been switched
back on after a power failure, an automatic
check is carried out that control turns on the
indicator lights and the displays for a few
seconds. Afterwards, the appliance can be
used normally.
Switching on and off
Press and hold the
second to switch on the appliance. To turn off
the appliance, press the
is emitted. The appliance will switch off
automatically after about 10 seconds of
inactivity.

Using the hob

All the appliance's control and monitoring
devices are located together on the front panel.
Recommended
diameter (mm)
170 - 190
240
Pan diameter
8 - 18 cm
20 - 26 cm
20 - 30 cm
20 - 30 cm
button for at least one
button until a sound
USE - 43