Cleaning And Maintenance; Software License - ResMed TxLink 2 User Manual

Configuration
TxLink 2 is initially configured as follows:
•
IP Address: acquired automatically by DHCP
• LEDs: During therapy, PAP device and Ethernet are disabled, and Power is dimmed
•
Analog DC output configuration as shown in the table below:
DC output Parameter
A Mask Pressure
B Patient Flow
C Leak
D Inspiration set pressure
E Expiration set pressure
Minute Ventilation
F

Cleaning and maintenance

Wipe the exterior of the device using an alcohol-based cleaning and disinfection wipe/solution (eg,
CaviWipes1 , Mikrozid
™
*Validated number of cycles is 260.
WARNING
•
Always disconnect the power cable from the power outlet before cleaning.
•
Ensure the power cable is dry before reconnecting.
•
Do not open or modify the device. There are no user serviceable parts inside. Repairs and
servicing should only be performed by an authorised ResMed service agent.
•
Do not use bleach, chlorine, or aromatic-based solutions, moisturizing or antibacterial soaps or
scented oils to clean the device. These solutions may cause damage and reduce the life of the
product.
Servicing
The TxLink 2 is intended to provide safe and reliable operation provided that it is operated and maintained
in accordance with the instructions provided by ResMed. There is no servicing necessary during the
lifetime of the device.
For more information, refer to the Titration Equipment Installation guide and EasyCare Tx 2 online help.

Software license

License Grant. Subject to the terms and conditions below, ResMed grants you, the owner and/or user of
this device, a perpetual, non-exclusive, non-sublicensable, personal, limited license to use the ResMed
Software solely in connection with the use of this device. All other rights are reserved by ResMed. You will
be deemed to have transferred and assigned this license to any person that acquires the owner's or the
user's rights in this device.
License Restrictions. Software included on or with this device is owned by or licensed to ResMed (the
"ResMed Software"). Neither the ResMed Software nor any intellectual property rights in the ResMed
Software are sold or assigned by ResMed. No person or entity is licensed or authorized to a) reproduce,
distribute, create derivative works, modify, display, perform, decompile or attempt to discover the source
code for the ResMed Software, b) remove or attempt to remove the ResMed Software from the ResMed
product, or c) reverse engineer or disassemble the ResMed product or the ResMed Software. For
avoidance of doubt, the foregoing restrictions are not intended to limit any licensee's rights to software
code incorporated into or distributed with the ResMed Software and licensed under the terms of any open
source, free or community software license (collectively, "Open Source Software").
)*. Wipe until visually clean following the manufacturer's instruction for cleaning.
™
Value
0 to 30 cm H O
2
-120 to 120 L/min
0 to 60 L/min
0 to 30 cm H O
2
0 to 30 cm H O
2
0 to 30 L/min
Voltage range
0 to 1 VDC
-1 to 1 VDC
0 to 1 VDC
0 to 1 VDC
0 to 1 VDC
0 to 1 VDC
English 5