Table of Contents
Advertisement
ATTENTION!!
THE
INSTALLATION
IGNITION OF THE BOILER MUST BE
PERFORMED BY QUALIFIED PERSONNEL
IN
COMPLIANCE
NATIONAL REGULATIONS REGARDING
INSTALLATION, AND IN CONFORMITY
WITH ANY REQUIREMENTS ESTABLISHED
BY LOCAL AUTHORITIES AND PUBLIC
HEALTH ORGANISATIONS.
Advice for the installer
This appliance is designed to produce hot water for
domestic use.
It should be connected to a distribution network for
domestic hot water that must be compatible with its
performance and power levels.
The use of the appliance for purposes other than those
be held responsible for any damage caused by improper,
incorrect and unreasonable use of the appliance or by the
failure to comply with the instructions given in this manual.
Installation, maintenance and all other interventions
must be carried out in full conformity with the governing
legal regulations and the instructions provided by the
manufacturer.
Incorrect installation can harm persons, animals and
possessions; the manufacturing company shall not be
held responsible for any damage caused as a result.
The applaince is delivered in a carton. Once you have
removed all the packaging, make sure the appliance is
intact and that no parts are missing. If this is not the case,
please contact your supplier.
Keep all packaging material (clips, plastic bags,
polystyrene foam, etc.) out of reach of children as it may
present a potential hazard.
AND
FIRST
WITH
CURRENT
In the event of a fault and/or malfunction, turn the
appliance off, turn off the gas cock and do not attempt to
Before any maintenance or repair work is performed on
the appliance, make sure you have disconnected it from
the electricity supply by switching the external bipolar
switch to the "OFF" position and removing the fuse.
All repairs, which should only be performed using
professional. Failure to comply with the above instructions
could compromise the safety of the appliance and
invalidate all liability on the part of the manufacturer.
In the event of any maintenance or other structural work
devices and their accessories, switch the appliance off by
switching the external bipolar switch to the "OFF" position
and shutting off the gas control valve.
devices.
Turn the appliance off and turn the external switch "OFF"
to clean the exterior parts of the appliance.
Clean using a cloth dampened with soapy water. Do not
use aggressive detergents, insecticides or toxic products.
If the appliance is used in full compliance with current
legislation, it will operate in a safe, environmentally-
If using kits or optional extras, make sure they are
authentic.
WARNING!!
Water with a temperature higher than 50°
cause serious burns.
Always verify water temperature before
use.
WARNING!!
The device must be activated only in
presence of water in the exchanger.
IMPORTANT!!
If the appliance is installed in a hard water area
(> 200 mg/l), a softener should be installed to
limit the amount of limescale building up in the
heat exchanger.
The guarantee does not cover damage
caused by limescale.
OVERVIEW
/
9
Advertisement
Table of Contents
