Changing Temp Units And Calibration In The Status Screen; Setting Temperature Calibration - Magellan Map 410 User Manual

The satellite positions are displayed in the Satellite Position Graph with the
satellite signal strengths on the Satellite Signal Chart.
2D/3D Icon
Satellite
Positions
Satellite
Signal
Strengths
Satellite
Numbers
Temperature
On the Satellite Position Graph and the Satellite Signal Chart, satellites
displayed in gray have weak signal strengths while satellites in black have
strong signal strengths. On the Satellite Signal Chart, satellites still
receiving information will display an empty bar.
The bottom of the SAT STATUS screen displays remaining battery power and
ambient temperature of the receiver. Power shown is the estimated battery
life when the receiver is operating on battery power.
Once the receiver has computed a position fix, the SAT STATUS screen will
be replaced by the POSITION screen.

Changing Temp Units and Calibration in the STATUS SCREEN

You have two options for customizing the SAT STATUS screen; TEMP
UNITS and TEMP CALIB.
Selecting Temp Units:
From the
Sat Status
screen.
Use UP/DOWN ARROW
ENTER
MARK
FAHRENHEIT or CELSIUS.

Setting Temperature Calibration

With your MAP 410 you have the ability to calibrate the temperature which
creates an offset from the factory settings to accommodate the environment
that you are in.
At any point in the above steps you may press the QUIT key, or highlight
RESET DFLT and press ENTER, to exit out of the TEMP CALIB screen.
12
3D
25
0 0 1 1 1 2
7 8 2 3 8 5
POWER
TEMP
Use UP/DOWN
ARROW KEYS to
MENU
highlight TEMP UNITS.
KEYS to highlight
North Indicator
STATUS
12
N
13
Satellite
8
Position Graph
18
7
Satellite
Signal Chart
Battery Life
25 ˚ Indicator
c
Light Icon
MENU
TEMP UNITS
TEMP CALIB
WAYPOINTS
ROUTES
SETUP
SUN/MOON
ENTER
FISH/HUNT
MARK
CONTRAST
ALARM/MSG
Magellan MAP 410 GPS Receiver
TEMP UNITS
FAHRENHEIT
CELSIUS