Intake Side Panel Removal
See
Figure
2-6. Intake side panel (C) must be removed
to access battery compartment, solenoid valve assembly,
and sediment trap.
Figure 2-6. Remove Intake Side Panel
1. Raise lid and remove front panel.
2. Use 4 mm hex key to remove two mounting screws
(D) and L-bracket screw (E).
3. Lift intake side panel up and away from generator.
4. Inspect for any hidden freight damage. Contact
freight carrier if damage is present.
NOTE: Always lift intake side panel straight up before
pulling away from enclosure. Do not pull panel away from
enclosure before lifting up (F).
Installation Guidelines for PWRgenerator Air-Cooled Generators
Customer Connections and Loose
Parts
See
Figure 2-7
and loose parts location.
shipped loose.
D
E
C
C
E
A
Customer electrical connection area
(behind access panel)
B
Sediment trap
F
C
Battery compartment (battery not supplied)
D
Positive (+) and negative (-) battery cables
E
Location of "Loose Shipped Parts"
Figure 2-7. Customer Connection Area and Loose
Rear Connections
013667
D
A
DC REbus output conduit hole
B
120VAC input for heater conduit hole (optional acces-
sory)
C
Fuel connection hole
D
Auxiliary shutdown switch
Unpacking and Inspection
and
Figure 2-8
for customer connections
Figure 2-10
Parts Location
Figure 2-8. Rear Connections
illustrates parts
A
B
D
012575
A
B
C
013414
9