Table of Contents
Advertisement
Chapter 7
Error message
No Template
Selected!
Setting Wireless
LAN Unsuccessful!
Try again
Memory Full!
Wrong Password!
Incorrect Value!
Noncompliant USB
device. Remove
Device!
Mass Storage
Operation error!
System Error! 01
System Error! 02
58
Solution
There is no template with the specified number. Specify a correct number.
When printing a template, an error is indicated if the specified template does
not exist.
The access point could not be found.
An access point for establishing a connection could not be specified.
Tape exceeding 39.37" (1 m) or incompatible files cannot be printed.
An error is indicated if data is transferred, causing the capacity of the user
storage area to be exceeded.
Is the administrator password correct?
Type in the correct password.
If you do not remember the password, use [Device settings] of the "Printer
Setting Tool" to reset the password. For more information, see Admin
Password on page 33.
Has a value outside of the allowable range been entered?
Type in a value within the allowable range.
Has a device been connected that is not supported by the USB host port?
An overcurrent was detected by the USB host port, or connection of an
unsupported device was detected. Turn off the printer, and then check the
connected device.
Is the printer in mass storage mode?
An error is indicated if the file system becomes corrupted or a file is copied while
a mass storage file is being processed. Turn off the printer.
If the error message is displayed, contact Brother Customer Service.
Advertisement
Table of Contents
