Troubleshooting - Polar Electro GH226-A Instruction Manual

Refrigerated prep counter
Table of Contents

Advertisement

Telephone Helpline: 1300225960
Cleaning the Condenser Filter
The condenser is part of the refrigeration system.
The condenser filter requires monthly cleaning.
Always disconnect power supply before carrying out
Routine Maintenance.
Failure to clean the condenser filter will reduce the
performance and life of your Polar unit and may
invalidate your warranty
These models have a removable filter which can be
cleaned with a vacuum cleaner.

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer. A POLAR agent or qualified technician must carry out repairs if required.
Fault
The appliance is
The unit is not switched on
not working
Plug or lead is damaged
Mains power supply fault
The appliance
Too much ice on the evaporator
turns on, but the
Condenser blocked with dust
temperature is
Drawers are not shut properly
too high/low
Appliance is located near a heat source
or air flow to the condenser is being
interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being stored in
the appliance
Appliance is overloaded
The appliance is
The appliance is not properly levelled
leaking water
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The drip tray is overflowing
The appliance is
Loose nut/screw
unusually loud
The appliance has not been installed in
a level or stable position
GH226-A_A5_v1_20211214.indb 5
GH226-A_A5_v1_20211214.indb 5
Probable Cause
Removable
filter
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Check mains power supply
Defrost the appliance
Clean the Condenser
Check drawers are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Empty the drip tray (if applicable)
Check and tighten all nuts and screws
Check installation position and change if
necessary
AU
AU
5
2021/12/14 10:09
2021/12/14 10:09

Advertisement

Table of Contents
loading

This manual is also suitable for:

G-series

Table of Contents