Troubleshooting; Technical Specifications - Polar Electro GH261 Instruction Manual

EN

Troubleshooting

A qualified technician must carry out repairs if required.
Fault
The appliance is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
The appliance Too much ice on the evaporator
turns on, but the
Condenser blocked with dust
temperature is too
Doors are not shut properly
high/low
Appliance is located near a heat
source or air flow to the condenser
is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
The appliance is The appliance is not properly
leaking water levelled
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The water container is damaged
The drip tray is overflowing
The appliance is Loose nut/screw
unusually loud
The appliance has not been installed
in a level or stable position

Technical Specifications

Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage Power
GH261 220- 110W
240V~
50Hz
AB090
150W
6
GH261_AB090_ML_A5_v1_20230627.indb 6 GH261_AB090_ML_A5_v1_20230627.indb 6
Probable Cause
Temperature
Current Capacity
Range
0.8A 2°C - 8°C 4 x 1/3GN +
1 x 1/2GN
1A 2°C - 8°C 6 x 1/4GN
Solution
Check unit plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Defrost the appliance
Clean the Condenser
Check doors are shut and seals are not
damaged
Move the appliance to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Consult a qualified Technician
Empty the drip tray (if applicable)
Check and tighten all nuts and screws
Check installation position and change if
necessary
Dimensions
Refrigerant
H x W x D mm
R600a 280 x 1440 x 435
R600a 280 x 1400 x 330
Weight
(kg)
45.2
31
2023/6/27 15:40 2023/6/27 15:40