Cleaning, Care And Maintenance; Troubleshooting; Technical Specifications - Polar Electro G Series Instruction Manual

Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• If left unused for any length of time, store the appliance with the door ajar.

Troubleshooting

A qualified technician must carry out repairs if required.
Fault
The appliance is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Fridge cabinet is not Temperature set incorrectly
cold enough
Condenser blocked with dust
Door is opened too often
Unit located near a heat source or air
flow to the condenser interrupted
Ambient temperature is too high
Appliance is overloaded
The appliance is The appliance is not installed in a
unusually loud level or stable position

Technical Specifications

Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage Power Current
DB109 220-240V~
50Hz
DB109_ML_A5_v1_20230522.indb 5
Probable Cause
Temperature
Range
85W 0.45A 0°C - 4°C
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Check temperature and reset if necessary
Consult a qualified Technician
Only open when necessary
Move the appliance to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Reduce the amount stored in the appliance
Check installation position and change if
necessary
Net Dimensions
Refrigerant
Capacity H x W x D mm
16L R600a 13g 452 x 312 x 379
EN AU
Weight
(kg)
18.3
5
2023/5/25 10:27:19