Before You Begin - Razor Power A Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because
your scooter was assembled and packed at the factory, there should not be any problems, even if the box has a few
scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 5 hours for charge (see page 5 for charging information).
Throttle
Collar Clamp
LED Lighted
Front Wheel
Required Tool
5 mm
Allen Wrench
Charger
(Note: Charger design may
vary from one shown)
Charger Port
ON/OFF Button
Kickstand
2.
Power Cut-off
Rear-Fender
Brake
Hub Motor
1.
3
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR SCOOTER.
Razor scooters have been built to
certain Razor design specifications.
The original equipment supplied
at the time of sale was selected
on the basis of its compatibility
with the frame, fork and all
other parts. Certain aftermarket
products may not be compatible
and will void the warranty.
Note: Electric scooter must be
moving at least 3 mph (5 km/h)
while pressing the push-button
throttle to engage motor.
Product ID Locations:
(See locations to the left)
1. Underneath Product
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• Power A
• Charger
• Owner's Manual
• Allen Wrench