Messages: E-Mails (Cp 1543Sp-1) - Siemens SIMATIC NET ET 200SP Operating Instructions Manual

Certificates for the CP 1543SP-1
Before certificates can be referenced in the program blocks for Secure Communication,
these certificates must be assigned to the Security module as device certificates via the local
certificate manager.
Requirement in the global security settings
To be able to assign the CP certificate of a communications partner, you need to first import
the certificates of the partner in the global certificate manager (Global security settings).
To make the assigned certificate known to the partner module, this certificate must be
entered in the list of trustworthy partner certificates after import.
Assign the certificates in the CP configuration
Select the following certificates in the CP configuration:
● Table "Device certificates":
The device certificate of the CP generated by STEP 7
● Table "Certificates of the partner devices":
The imported certificate of the partner
4.10

Messages: E-mails (CP 1543SP-1)

Validity
Validity: CP 1543SP-1
You will find the description of the CP 1542SP-1 IRC in the relevant configuration manual.
Note
E-mails via the message editor
The following information applies to e-mails configured with the message editor.
Sending e-mails via OUC program blocks is not affected.
Requirements
If important events occur, the CP can send e-mails to communications partners.
Note the following requirements in the CP configuration for the transfer of e-mails:
● The security functions are enabled.
● The time of the CP is synchronized.
● Configuring the "E-mail configuration" parameter group
You require the recipient addresses to configure the messages.
CP 154xSP-1
Operating Instructions, 12/2019, C79000-G8976-C426-05
4.10 Messages: E-mails (CP 1543SP-1)
Configuration
75