Replacing The Burner Parts - Fisher & Paykel OR30 Manual

2. Gently close the drawer completely. The safety catches will automatically hook into place.
Burner Parts
• You can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean spills regularly
before they become burnt on. Do not wash these parts in a dishwasher.
• After cleaning, check that the burners and their flame spreaders are dry before replacing correctly.
• It is very important to check that the burner flame spreader and the cap have been correctly positioned. Failure
to do so can cause serious problems.
• Check that the ignitor is always clean to ensure trouble free sparking. It must be cleaned very carefully using a
toothbrush and methylated spirits.
To avoid damage to the electronic ignition, do not try to light a burner without all burner parts in
place.

Replacing the Burner Parts

• Carefully replace the burner parts as per the following illustrations.
• Fit the flame spreader to the housing as shown below. Make sure the burner is not able to rotate.
Check that:
• The ignitor is always clean to ensure trouble-free sparking.
• The probe is always clean to ensure correct operation of the safety valves.
• The flame spreaders are clean and the holes are not clogged.
https://producthelp.fisherpaykel.com/us/Cook/Ranges/Dual_Fuel/OR30SCG6R1/User_Guide_OR30SCG6R1/07_Care_and_...
Updated: Sat, 09 Jul 2022 14:42:33 GMT
Powered by
12