Back Panel; Connectors, Jumpers & Slots; Floppy Disk Drive Connector: Jfdd1; Hard Disk Connectors: Ide1/2 - MSI E7210 Master-FARM User Manual

MS-9149 ATX Server Board

Back Panel

Parallel
Mouse
USB
Keyboard COM A
KB/Mouse Connector
VGA Port
VGA Connector
(DB 15-pin)
USB Ports
COM2
PIN SIGNAL
1 VCC
2-10
VGA LAN1 LAN2
RJ-45 LAN Jack
8 1
Gigabit LAN Pin Definition
1 D0P Differential Pair 0+
2 D0N Differential Pair 0-
3 D1P Differential Pair 1+
4 D2P Differential Pair 2+
5 D2N Differential Pair 2-
6 D1N Differential Pair 1-
7 D3P Differential Pair 3+
8 D3N Differential Pair 3-
Serial Ports
PIN SIGNAL
Connectors, Jumpers & Slots

Floppy Disk Drive Connector: JFDD1

The mainb oard provides a stand ard floppy disk d rive connector t hat
supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.

Hard Disk Connectors: IDE1/2

The mainboard has a 32-bit Enhan ced PCI IDE an d Ultra DMA 33/66/
100 co ntroller t hat provid es PIO mod e 0~4, Bus Master, and Ultra DMA 33/
66/100 fun ction. Yo u can co nnect u p to fo ur h ard dis k drives, CD-ROM,
120MB Floppy (reserved for future BIOS) and other devices. These connec-
tors support the provid ed IDE hard disk cable.
JFDD1
IDE1 (Primary IDE Connector)
The first hard drive should always be connected t o IDE1. IDE1 can
connect a Master and a Slave driv e. You must configure seco nd hard
drive to Slave mode by setting the jumper accordingly.
IDE2 (Secondary IDE Connector)
IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install t wo hard disks on cable, you mu st configure the
second d rive to Slave mode by setting i ts jumper. Refer to the
hard disk documentatio n suppl ied by hard disk vendors for
jumper setting instructions.
Hardware Setup
IDE2
IDE1
2-11