Table of Contents
Advertisement
bench Installation
1.
Remove Blower Access Panels. See Figure 2.
2.
Place Blowers onto blower brackets. See Figure 3.
3.
Bend tab as shown in Figure 4 and secure with
(2) screws.
HAND BEND
TAB INWARD
HAND BEND
TAB INWARD
4.
Remove protective connectors on Wire Assembly from
fireplace and discard. Connect Wire Harness to both blowers
and the other end to the Wire Assembly supplied with the
fireplace. See Figure 5.
Page 10
bLOWER INSTALLATION
Sharp edges. Use protective gloves when installing.
Figure 2
Figure 3
Figure 4
CAUTION
TO WIRE ASSEMBLY
(MODULE)
TO WIRE ASSEMBLY
5.
Replace Blower Access Panels removed in step 1.
See Figure 1.
Installation After Placement of Unit in Wall
1.
Remove the following items. See Figure 6.
•
Screen barrier (See Homeowner's Manual, Maintenance
and Service).
•
Glass Frame Assembly (See Homeowner's Manual,
Maintenance and Service).
•
Liners (See separate liner instruction document).
2.
Remove front and rear burner. See Figure 7.
(MODULE)
Figure 5
Figure 6
Figure 7
38745-4-0319
Advertisement
Table of Contents
