5-4-2. Curvature Adjustment (1 group frame service
assy)
Note: Curvature Adjustment (1 group frame service assy) is done by
increasing or decreasing the thickness of the washer.
Refer to "2-2. DISASSEMBLY", disassemble the lens, and
change the thickness of the washer.
Adjusting Procedure
1. Set the zoom to the TELE end.
2. Increase or decrease the thickness of the 1 group spacer washer
to adjust the curvature.
Front focus: Make the washer thicker.
Rear focus: Make the washer thinner.
1 group spacer washer
1 GROUP SPACER WASHER
Part No.
4-696-667-01
4-696-667-11
4-696-667-21
4-696-667-31
4-696-667-41
4-696-667-51
4-696-667-61
4-696-667-71
4-696-667-81
4-696-667-91
3. Perform the check and adjustment repeatedly until the curvature
is resolved.
Note: If the curvature cannot be resolved even after the adjust-
ment, replace the 1 group frame service assy.
Thickness t (mm)
0.02
0.03
0.05
0.08
0.10
0.15
0.20
0.25
0.30
0.35
5-22
5-4-3. Curvature Adjustment (mount service assy)
Note: Curvature Adjustment (mount service assy) is done by increas-
ing or decreasing the thickness of the washer.
Refer to "2-2. DISASSEMBLY", disassemble the lens, and
change the thickness of the washer.
Adjusting Procedure
1. Set the zoom to the WIDE end.
2. Increase or decrease the thickness of the FB washer to adjust the
curvature.
Front focus: Make the washer thicker.
Rear focus: Make the washer thinner.
FB WASHER
Part No.
4-696-674-01
4-696-674-11
4-696-674-51
4-696-674-21
4-696-674-31
4-696-674-41
3. Perform the check and adjustment repeatedly until the curvature
is resolved.
Note: If the curvature cannot be resolved even after the adjust-
ment, replace the mount service assy.
SEL1224G
FB washer
Thickness t (mm)
0.02
0.03
0.05
0.10
0.15
0.20