Start-Up Checklist - Goodman APD 14 M Series Installation Instructions Manual

Start-Up Checklist

Residential Package - (Indoor Section)
Line Voltage (Measure L1 and L2 Voltage)
Secondary Voltage (Measure Transformer Output Voltage)
Blower Amps
Heat Strip 1 - Amps
Heat Strip 2 - Amps
BLOWER EXTERNAL STATIC PRESSURE
Return Air Static Pressure
Supply Air Static Pressure
Total External Static Pressure (Ignoring +/- from the reading above, add total here)
Return Air Temperature (Dry bulb / Wet bulb)
Cooling Supply Air Temperature (Dry bulb / Wet bulb)
Heating Supply Air Temperature
Temperature Rise
Delta T (Difference between Supply and Return Temperatures)
Gas Inlet Pressure
Gas Manifold Pressure (Low Fire)
Gas Manifold Pressure (High Fire)
Gas Type (NG) = Natural Gas / (LP) = Liquid Propane
Residential Package - (Outdoor Section)
Supply Voltage (Measure L1 and L2 Voltage)
Compressor Amps
Condenser Fan Amps
Suction Circuit (Pressure / Suction Line Temperature)
Liquid Circuit (Pressure / Liquid Temperature)
Outdoor Air Temperature (Dry bulb / Wet bulb)
Additional Checks
Check wire routings for any rubbing
Check product for proper draining
Check for kinked pressure switch tubing.
Check flue elbow for alignment and clamp tightness.
Check screw tightness on blower wheel.
Check factory wiring and wire connections.
Check screw tightness on Outdoor Motor and Blade
Check product for proper clearances as noted by installtion instructions
°F to °C formula: (°F - 32) divided by 1.8 = °C
ELECTRICAL
TEMPERATURES
GAS PRESSURES
ELECTRICAL
PRESSURES / TEMPERATURES
SUPERHEAT / SUBCOOLING
°C to °F formula: (°C multiplied by 1.8) + 32 = °F
Model Number
Serial Number
L1 - L2
R - C
L1 - L2
PSIG
PSIG
SH
30
IN. W.C.
IN. W.C.
IN. W.C.
DB °F WB °F
DB °F WB °F
DB °F
DB °F
DB °F
IN. W.C.
IN. W.C.
IN. W.C.
TEMP °F
TEMP °F
DB °F WB °F
SC