Cisco Catalyst 9130 Manual page 21

Introduction to Cisco Catalyst 9130 Access Point with 9104 Stadium Antenna
Danger
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Before you begin
You must supply these tools and materials:
• Shielded outdoor-rated Ethernet (CAT 6 or CAT 6A) cable with a diameter of 0.2 to 0.35 inch (5 to 9
mm)
• CAT 6 RJ-45 connector installation tool
• Adjustable wrench or 28–mm box wrench
• CAT 6 / CAT 6A gland ordered separately with AIR-ACC-CAT6= kit
Procedure
Step 1 Disconnect power to the power injector and ensure no power source is connected to the antenna.
Step 2
Ensure a 6 AWG ground wire is connected to the antenna (see
Step 3 Remove the covering cap from the PoE port.
Step 4
Loosen and remove the cable sealing nut of the cable gland by turning it counterclockwise.
Note
Caution
Step 5 Insert the Ethernet cable's unterminated end through the sealing nut end of the cable gland.
Pass the Ethernet cable through the appropriate size cable seal and pull several inches of cable through the
adapted components.
Note
Step 6
Install the CAT 6/6A RJ-45 connector on the Ethernet cable's unterminated end using your Ethernet cable
installation tool.
Follow the common CAT6/6A Ethernet connector installation procedures. Fold and crimp the connector metal
strain lug end over the outer cable jacket, foil and ground wire if equipped.
Note
Step 7
Carefully connect the RJ45 cable connector to the PoE port on the antenna.
Step 8 Slide the cable gland with the rubber seal towards the antenna over the RJ45 connector.
Screw the threaded screw nut of the body into the antenna, and hand-tighten it.
Step 9
Slide the cable seal into the Clamp Ring fluted end, be sure it is fully seated.
Verify that the cable gland has a rubber seal and ensure that it is not damaged.
If the cable gland and rubber gasket is not installed correctly, it causes the cable grip to leak.
Install the proper cable seal that fits the OD of the Ethernet cable used.
• Position and insert load bar with notches aligned to connector as shown in the figure
24: CAT 6/6a Cable Gland Assembly, on page
• Ensure individual conductor sequence matches opposite connection end. Typical sequence
follows the T568B pinout standard.
Introduction to Cisco Catalyst 9130 Access Point with 9104 Stadium Antenna
Installing a CAT 6/6A Ethernet Cable and Gland Assembly to the Antenna
Grounding the Antenna, on page
20).
18).
(Figure
21