Connecting An Ethernet Cable To The Access Point - Cisco Catalyst 9130 Manual

Introduction to Cisco Catalyst 9130 Access Point with 9104 Stadium Antenna

Connecting an Ethernet Cable to the Access Point

Installing a CAT 5e Ethernet Cable and Gland Assembly to the Access Point
Figure 23: CAT 5e Cable Gland Assembly
1
2
3
Before you begin
You must supply these tools and materials:
• Shielded outdoor-rated CAT 5e Ethernet cable with a diameter of 0.2 to 0.35 inch (5 to 9 mm)
• CAT 5e RJ-45 connector and installation tool
• Adjustable wrench or 28–mm box wrench
Procedure
Step 1
Disconnect power to the power injector and ensure all power sources to the AP are turned off.
Danger
Step 2 Ensure a 6 AWG ground wire is connected to the AP (see
Step 3
Remove the covering cap from the PoE port.
Step 4
Loosen and remove the cable sealing nut of the cable gland by turning it counterclockwise.
Note
CAT 5e RJ45 Plug
Gasket
Clamp ring
This unit might have more than one power supply connection. All connections must be removed
to de-energize the unit. Statement 1028
Verify that the cable gland has a rubber seal and ensure that it is not damaged.
Introduction to Cisco Catalyst 9130 Access Point with 9104 Stadium Antenna
Connecting an Ethernet Cable to the Access Point
4 Screw nut
5 Seal
6 Thread-lock sealing nut
Grounding the Antenna, on page 18).
19