Table of Contents
Advertisement
172 Light and sight
Please observe the country-specific laws on the
use of rear fog lamps.
Operating the combination switch for the lights
1
High beam
2
Turn signal light, right
3
Headlamp flashing
4
Turn signal light, left
Use the combination switch to select the
#
desired function.
Switching on high beam
Turn the light switch to the L or Ã
#
position.
Push the combination switch in the direction
#
of arrow 1.
When the high beam is activated, the indicator
lamp for low beam L will be deactivated
and replaced by the indicator lamp for high
beam K.
Switching off high beam
Push the combination switch in the direction
#
of arrow
1
or pull it in the direction of arrow
3.
Headlamp flashing
Pull the combination switch in the direction of
#
arrow 3.
Turn signal light
To indicate briefly: push the combination
#
switch briefly to the point of resistance in the
direction of arrow
2
or 4.
The corresponding turn signal light will flash
three times.
To indicate permanently: push the combina-
#
tion switch beyond the point of resistance in
the direction of arrow
2
or 4.
Vehicles with Active Lane Change Assist:
A turn signal indicator activated by the
R
driver may continue to operate for the
duration of the lane change.
If the driver indicated directly beforehand
R
but a lane change was not immediately
possible, the turn signal indicator may acti-
vate automatically.
Advertisement
Table of Contents
