System Hardware Installation - Agilent Technologies 5DX II Series Installation Manual

TABLE 3
Configuration #
1
2
3
4
* Loader height is not recommended below 88.1 cm (34.68 in.)
Variance between Min and Max is due to the 19mm adjustment in the foot receptacle.

System Hardware Installation

Site preparation and movement to the final location should be
complete at this stage. Verify correct placement of the main unit, and
subsystems (such as electronics bay, user interface and monitor:) (See
Figure 5
using the following procedure:
NOTE
Loader height Configuration Chart (Sample)
Assembly Setup
Spacer A+C
(inches)
Spacer B+C
Spacer A+B+C
Spacer A+B+B+C
) with your customer. Begin assembly of the 5DX system
The forklift will be needed to unpack and install the loaders,
make sure that it and its operator remain present.
Minimum Height Maximum Height
Adjustment Adjustment
89.00 cm 90.90 cm
(35.04)
84.58 cm 86.48 cm
(33.30)
92.18 cm 94.10 cm
(36.29)
95.35 cm 97.26 cm
(37.54)
Installation - 9
(35.79)
(34.05)
(37.04)
(38.29)