Appendix G: Power Failure - Lorex LW2902 Instruction Manual

Appendix G: Power Failure

A power failure may interrupt recording modes on the system. After power is restored, the
following will occur:
• The system will restart in Auto Sequence Mode + Motion Recording – this ensures that
some form of recording will be immediately active on the system
NOTE: If you had a different display view or recording mode set when the power failure occurred,
you will need to re-apply the previous display view and recording mode.
A flashing Power Failure icon will appear on-screen – the Power Failure icon indicates
that a power failure occurred while the system was
was on-screen)
160602-1.AVI
Figure 16.0 Power Failure icon
NOTE: The flashing icon appears
occurred. The flashing icon will disappear when you press buttons on the receiver or remote
control.
62
R E C
R E C
only
if the system was actively recording when the power failure
actively recording (i.e. "REC" icon
C a m 1
C a m 1
2009 07 17
16:32:05
Power Failure
icon