Table of Contents
Advertisement
■ Battery charger
NOTE: The transceiver MUST be turned OFF while charging. Otherwise:
- The battery will not be charged correctly.
- The battery life may be shortened.
NOTE: Be sure the tabs on the
transceiver are correctly aligned with the
guide rails inside the battery charger.
Guide rail
D Supplied battery charger
Charging time: Approximately 4 hours for the BP-306
CP-26* (for a 12 V
Turn OFF
cigarette lighter socket)
can be used instead of
the power adapter*.
Battery charger
* May not be supplied, or the shape may be
different, depending on the transceiver version.
L "Charging" is displayed and bars of the
battery icon scroll while charging.
L "Full Charge" is displayed when the
battery has been fully charged, and then
disappears after 10 seconds.
BATTERY CHARGING
D Mounting the Battery charger
Tabs
NOTE:
• DO NOT transmit while charging.
If you need to transmit, remove the
transceiver from the charger, and then
turn ON the transceiver.
• If the battery pack does not properly
charge, remove the transceiver from the
charger and insert the transceiver into
the charger again.
L If error is detected, "Charging Error" is
Power
displayed.
adapter*
• The CP-26 is equipped with a 1.5 A fuse.
If the fuse blows, repair the problem,
then replace it with a new rated fuse.
DO NOT use fuses with amp ratings
other than the ratings written below.
Supplied screws
Fuse
CP-26: (1.5 A/250 V)
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
10
Advertisement
Table of Contents
