Supplied Battery Charger; Optional Battery Case - Icom IC-M36 Instruction Manual

■ Supplied battery charger

(Optional for some transceiver versions)
ï Charging connections
Do not charge batteries other than the BP-252.
q Attach the BC-173 to a flat surface, such as a desk, with
the two supplied screws, if necessary.
w Connect the power adapter as shown below.
e Insert the battery pack with/without the transceiver into
the charger.
• The charge indicator lights orange.
• The charge indicator blinks orange (or orange/green alter-
nately) when the protector is activated.
r Charge the battery pack approximately 10 hours, depend-
ing on the remaining power condition.
• The charge indicator lights green when charging is completed.
Battery pack
Charging indicator
lights orange when
the battery pack
(with/without the
transceiver) is
inserted.
To an
AC Outlet
Power adapter*
* Not supplied,
depending on the Supplied
transceiver version.
screws

■ Optional battery case

When you would like to use the optional AAA(LR03) size
battery case (BP-251), install the batteries as illustrated
below. Be sure to observe the correct polarity.
Battery pack
+ Transceiver
Turn OFF
NOTE: The charging
timer of the BC-173
stops charging after ap-
proximately 14 hours.
BC-173
BATTERY CHARGING
CAUTION:
• When installing batteries, make sure they are all the
same brand, type and capacity. Also, do not mix new and
old batteries together.
• Keep battery contacts clean. It's a good idea to occa-
sionally clean battery.
• When using the optional battery case, output power
level is 2 W (at high).
NOTE: The transceiver may sink when the optional bat-
tery case is attached. (Depends on the weight of the in-
stalled batteries.)
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
23