Maintenance And Troubleshooting - NordicTrack C3 Si User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, or if the audio
from the sound system stops intermittently, the batter-
ies should be replaced; most console problems are
the result of low batteries. See assembly step 5 on
page 8 for replacement instructions.
Note: If you use the sound system regularly, it is rec-
ommended that you purchase an optional
manufacturer-supplied AC adapter (see assembly step
5 on page 8).
If the handgrip pulse sensor does not function prop-
erly, see step 5 on page 15.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, you must first remove the left pedal and the
left front shield. Using an adjustable wrench, turn the
left pedal clockwise and remove it. Next, remove all
the screws from the left and right front shields; there
are two sizes of screws in the front shields–note
which size of screw you remove from each hole.
Then, gently pull the left front shield away from the
frame.
Locate the Reed Switch (46). Turn the Pulley (29) until
a Magnet (30) is aligned with the Reed Switch. Next,
loosen, but do not remove, the indicated M4 x 16mm
Screw (57). Slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Screw.
Turn the Pulley for a moment. Repeat these actions
until the console displays correct feedback. When the
Reed Switch is correctly adjusted, reattach the front
shields and the left pedal.
46 57
30
21
29