Ford EVEREST 2009 Manual page 252

EVEREST_F8M7-10-09B_Edition1 Page252
Tuesday, February 10 2009 12:55 AM
Maintenance and Care
Owner Maintenance
Front direction indicator lights,
Parking lights
1. If you are changing a bulb in the right
headlight unit, start the engine, turn the
steering wheel all the way to the right,
and turn off engine. If you are
changing a bulb in the left headlight
unit, turn the steering wheel to the left.
2. Make sure the headlight switch is off.
3. Turn the centre section of the plastic
retainers anticlockwise and remove
them, then partially peel back the
mudguard.
Removal
Installation
4. Turn the socket and bulb assembly
anticlockwise and remove it.
5. Disconnect the bulb from the socket.
Front direction
indicator lights
Parking lights
í
8-38
Some models.
Form No.F8M7-10-09B
Black plate (252,1)
6. Install the new bulb in the reverse order
of removal.
Ground illumination lights
Due to the complexity and difficulty of
the procedure, the bulbs must be replaced
by an expert repairer, we recommend an
Authorised Ford Repairer.
Side-direction indicator lights
Due to the complexity and difficulty of
the procedure, the LED bulbs must be
replaced by an expert repairer, we
recommend an Authorised Ford Repairer.
High-mount brake light
Due to the complexity and difficulty of
the procedure, the LED bulbs should be
replaced by an expert repairer, we
recommend an Authorised Ford Repairer.
Brake lights/Tail lights (Except India),
Rear direction indicator lights
1. Open the back door.
2. Turn the bolts anticlockwise and
remove them.
3. Pull the unit rearward to remove it.
4. Turn the socket and bulb assembly
anticlockwise and remove it.
í
í