Ford EVEREST 2009 Manual page 136

EVEREST_F8M7-10-09B_Edition1 Page136
Tuesday, February 10 2009 12:54 AM
Driving Your Ford
Switches and Controls
NOTE
Because heavy ice and snow can jam
the wiper blades, the wiper motor is
protected from motor breakdown,
overheating and possible fire by a
circuit breaker. This mechanism will
automatically stop operation of the
blades, but only for about 5 minutes.
If this happens, turn off the wiper
switch and park off the right-of-way,
and remove the snow and ice.
After 5 minutes, turn on the switch and
the blades should operate normally. If
they do not resume functioning, consult
an expert repairer, we recommend an
Authorised Ford Repairer as soon as
possible. Drive to the side of the road
and park off the right-of-way. Wait until
the weather clears before trying to drive
with the wipers inoperative.
qWindscreen Wipers
Turn the wipers on by pulling the lever
down.
Intermittent
INT
Low speed
1
2 High speed
5-46
Form No.F8M7-10-09B
Black plate (136,1)
For a single wiping cycle, push the lever
up to .
Mist
Variable-speed intermittent wipers
Set the lever to INT and choose the
interval timing by rotating the ring.
INT ring
qWindscreen Washer
Pull the lever toward you and hold it to
spray washer fluid.
NOTE
With the wiper lever in the OFF or INT
position, the wipers will operate
continuously until the lever is released.
OFF
Washer