Advanced Display Module (Adm) Operation - Graco HFRL Setup And Operation Manual

Advanced Display Module (ADM) Operation

When main power is turned on by turning the main
power switch (MP) to the ON position, the splash
screen will be displayed until communication and initial-
ization is complete.
To begin using the ADM, the machine must be on and
enabled. To verify the machine is enabled, verify the
System Status Indicator Light (CB) is illuminated green,
see F . 7 on page 24. If the System Status Indicator
IG
Light is not green, press the ADM Power On/Off (CA)
button . The System Status Indicator Light will illu-
minate yellow if the machine is disabled.
If the machine is in the Disabled mode screen press
repeatedly to select a different operating mode.
Perform the following tasks to fully setup your system.
1. Set general system settings. See Advanced
Screen 1, page 71.
2. Set units of measure. See Advanced Screen 2,
page 71.
3. Enable/disable system features. See Advanced
Screen 3, page 72.
4. Define control mode, dispense mode, and pump
information. See System Screen 1, page 65.
5. Define dispense valve and other system settings.
See System Screen 2, page 65.
6. Define labels and other system settings. See Sys-
tem Screen 3, page 66.
3A2175Z
Advanced Display Module (ADM) Operation
7. If L-Head is installed, define L-Head control details.
See System Screen 3, page 66.
8. Define level sensors and refill settings. See Supply
Screen, page 68.
9. If Night mode will be used, define Night mode set-
tings. See Conditioning Screen 3, page 70.
10. Calibrate machine. See Calibration Screen, Main,
page 64.
11. Define shots. See Shots Screen, page 61.
12. Define sequences. See Sequences Screen,
page 63.
13. If desired, view/reset counters. See Maintenance
Screen, page 68.
57